Jobs in Zambia and Zimbabwe

Hitachi Construction Machinery Zambia is Currently Recruiting Welders

by ·


Welcome to Jobsjobscareers. This website helps you to achieve your career dream by connecting you to vacancies from Top Companies in Zambia. Job Seekers also have the opportunity to access the best articles for career growth and development. We strongly advise graduates to beware of fake job alerts and to make sure not to pay money before getting a Job. All job vacancies are free, you don’t pay to apply

  • Company: Hitachi Construction Machinery Zambia
  • Location: Zambia
  • State: Lusaka
  • Job type: Full-Time
  • Job category: Engineering Jobs in Zambia

Hitachi Construction Machinery Zambia is looking for a suitably qualified individual to fill in the below vacancy;

POSITION: WELDER G3 -1 VACANCY

REPORTS TO – WELDING SUPERVISOR

BRANCH: REMAN WORKSHOP, LUSAKA

Duties and Responsibilities

  • Will perform a step by step process of remanufacturing from either drawing or Original Equipment specifications and deliver within set time frame.
  • Apply engineering principles to construct and analyze structural systems related to the machines, pumps, cylinders and drives for a large variety of equipment.
  • Perform Arc gouging for removal of flaw in structural components
  • Perform pre heat and post heat tests where the material is thicker
  • Conduct flaw detection on structural components with Ultrasonic or Magnetic flaw detector
  • Diagnose the problems, locate the cause, repair any other secondary problems caused by the initial problems.
  • Analyze faults in existing, newly or used equipment, then rectify those faults by machining or other interventions, in order to resell the component as equivalent to new.
  • Ensure the correct isolation and lockout procedures are followed.
  • Develop and interpret two-dimensional engineering drawings of Components, then plan and cost-effectively carry out the remanufacture or repair of those components.
  • Recondition specific components and spares for installation.
  • Conduct the performance inspection with the programmed testing rig to ensure correlation with original component/drawing.

Minimum Qualifications and Experience

  • Must have a full Grade 12 School Certificate.
  • Must have an Artisan qualification- Advanced certificate in metal fabrication.
  • Should be able to use a wide range of precision measuring instruments
  • Must have 3 years minimum experience in the related field and broad knowledge on Cylinders, Pumps and Hydraulic Motors and experience in welding cast iron.
  • The candidate should be a holder of a valid driver’s license.

If you meet the above requirements, please send your detailed C.V, copies of certificates and a cover letter to:

The Human Resource Manager,

Hitachi Construction Machinery Zambia, Co; Ltd.

KK International Airport Road, Plot 2350/M

P.O Box 30182, Lusaka.

Or email in a single document to; [email protected]

The closing date for applicants is Monday 19th October 2020

NOTE: All applicants are thanked for their interest, and only shortlisted candidates will be communicated.